How to keep the data stored in flash after DFU

[Jorgewu]

Hi all:

I stored some settings in flash in the address 0x00077000 and this address is got by the function of pstorage_register().

However this area will be erased by my DFU, the DFU is refer the sample code of the project of dual_bank_ble_s132 in the SDK. V11. Is any setting or parameter needed be revised to avoid this area erased by DFU? My development enviroment: NRF52/IAR7.4/SDV2.01/SDK V11.0

Thanks…

[Adrian Eggenberger]

Hi,

The bootloader implementation in the example of the SDK splits the full area between softdevice end and bootloader start into two sections (dual DFU). The upper section is erased at the beginning of the DFU to store the new firmware. This is the reason your data is erased. To preserve a user data region below the bootloader the define for DFU_APP_DATA_RESERVED should be modified.

In your case you should preserve at least three times the CODE_PAGE_SIZE to prevent erasing of the data above 0x77000.

Regards Adrian

[bjorn-spockeli]

As @adrian says, if there is a valid application, softdevice and Bootloader, and you update the bootloaderonly, then you will branch to the application and not the bootloader after the DFU is finished.