Is it possible to use the NRF52832 UART in half-duplex single-wire mode, by assigning TXD and RXD to the same GPIO, setting the GPIO drive to disconnect '1' and using a pull-up resistor?
Is it possible to use the NRF52832 UART in half-duplex single-wire mode, by assigning TXD and RXD to the same GPIO, setting the GPIO drive to disconnect '1' and using a pull-up resistor?
Hi!
The problem is now solved. The configuration of uart pin direction works correctly. It works by rebuilding the project, not by building (F7 in Keil IDE) the project.
hi joojoo. This is my problem. can you give me your full code, pls? Thank you very much.
hi joojoo. This is my problem. can you give me your full code, pls? Thank you very much.