This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Why my custom board can't be detected by jlink after download softdevice

I make a custom board with nRF52832, the nRFgo Studio can find the device before I download anything, then I down do erase all and download the softdevice132, after this I want to download the app to the board, but it failed, I found the Jink can't detect the device;

Parents
  • I am having this exact problem,

    I solder down a nRF52832, power up, draws just over 4mA

    i use nrfprog to erase, all erased ok

    i use nrfprog to flash softdevice, it flashes, then afterwards current drops off to low uA

    Now i cant connect using nrfprog, just get a message saying "cannot connect to any nRF device"

    I thought the first time i have a board problem, so i checked everything, hot-air removed the nRF52832, put a new one down and exactly the same thing has happened again

    Its a custom board

    softdevice 132

    jlink can not now detect the device

    any ideas?

    thanks

Reply
  • I am having this exact problem,

    I solder down a nRF52832, power up, draws just over 4mA

    i use nrfprog to erase, all erased ok

    i use nrfprog to flash softdevice, it flashes, then afterwards current drops off to low uA

    Now i cant connect using nrfprog, just get a message saying "cannot connect to any nRF device"

    I thought the first time i have a board problem, so i checked everything, hot-air removed the nRF52832, put a new one down and exactly the same thing has happened again

    Its a custom board

    softdevice 132

    jlink can not now detect the device

    any ideas?

    thanks

Children
Related