• State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 63 subscribers
  • Views 1614 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 116414
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Don't stay in sleep mode after switch off voltage

1_andi

Hi,

for our prototyp we use a NRF52. When i flash the device, it will always be go in sleep mode after a duration of time and stay in there.

Is there an interrupt which wake it up?

The workaround from Errata for the Engineering A was also implemented.

Thank for your help.

Parents
  • 0

    well it depends on your application isn't it? the SD will detect that there is an application and just jump the control over it upon boot up. Then if the application is going to sleep mode then it is application responsibility to configure a wakeup source. The Errata 11 is only valid for Eng A and if you have configured PORT event for wakeup.

Reply
  • 0

    well it depends on your application isn't it? the SD will detect that there is an application and just jump the control over it upon boot up. Then if the application is going to sleep mode then it is application responsibility to configure a wakeup source. The Errata 11 is only valid for Eng A and if you have configured PORT event for wakeup.

Children
No Data
Related