• State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 63 subscribers
  • Views 1615 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 116414
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Don't stay in sleep mode after switch off voltage

1_andi

Hi,

for our prototyp we use a NRF52. When i flash the device, it will always be go in sleep mode after a duration of time and stay in there.

Is there an interrupt which wake it up?

The workaround from Errata for the Engineering A was also implemented.

Thank for your help.

Parents
  • 0

    At the moment we are using nrf52 Eng A. So the Errata 11 must be implemented. I have configured PORT event for wakeup. If the nrf52 are flashed and have vcc, the sleep mode are ok. When we loose the vcc, disconnect Accu or exhaust battery, the device don't stay in sleep mode. Is there a register who loose data for it?

Reply
  • 0

    At the moment we are using nrf52 Eng A. So the Errata 11 must be implemented. I have configured PORT event for wakeup. If the nrf52 are flashed and have vcc, the sleep mode are ok. When we loose the vcc, disconnect Accu or exhaust battery, the device don't stay in sleep mode. Is there a register who loose data for it?

Children
No Data
Related