Attachments (0)
Nordic Case Info
  • Case ID: 116516
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Send Data from nrf51-dk to Esp8266

June1993

Hi all Nordic developers,

I am currently working on nrf51 to scan all the nearby beacon and then i wish to send the data to the esp8266. I already able to scan all the beacon, and it's working. However, i face difficulties to push the scan result to the ESP8266. Is it possible to do that? If yes, is that any method, or suggestions to do that??

Parents
  • 0

    Am I correct to assume that the nRF51 and the ESP8266 is on the same board? If so, it should be possible for them to communicate using SPI, I2C or UART, as all are supported by both devices.

  • 0 in reply to Einar Thorsrud

    Hi, thank you for the answer.I try the solution and i am confusing on the coding to transmit the scan result(eg. Peripheral Address and Rssi) to the UART Terminal automatically.Is there any example code for this??

Reply
  • 0 in reply to Einar Thorsrud

    Hi, thank you for the answer.I try the solution and i am confusing on the coding to transmit the scan result(eg. Peripheral Address and Rssi) to the UART Terminal automatically.Is there any example code for this??

Children
No Data
Terms of service