[Current consumption with sd_app_evt_wait]

[annapalu]

Hi all,

i use a nrf52 and in product specification i find the table about the low power mode and their consumption . Capter 17.1.

• ION_RAMOFF_EVENT System ON, No RAM retention, Wake on any event 1.2 μA
• ION_RAMON_EVENT System ON, Full RAM retention, Wake on any event 1.5 μA
• ION_RAMOFF_RTC System ON, No RAM retention, Wake on RTC 1.9 μA
• IOFF_RAMOFF_RESET System OFF, No RAM retention, Wake on reset 0.7 μA
• IOFF_RAMOFF_GPIO System OFF, No RAM retention, Wake on GPIO 1.2 μA
• IOFF_RAMOFF_LPCOMP System OFF, No RAM retention, Wake on LPCOMP 1.9 μA
• IOFF_RAMOFF_NFC System OFF, No RAM retention, Wake on NFC field 0.7 μA
• IOFF_RAMON_RESET System OFF, Full RAM retention, Wake on reset 1.0 μA

I use in my code the sd_app_evt_wait(), but i don't understand how go in sleep and then the consumption that i must expect.

Someone can, please give me a clarification, about this? Thanks, Anna

[Stefan Birnir Sverrisson]

Hi Anna

Please look at the explanation in the nRF51 current consumption guide, section about "Low power mode with BLE softdevice". That should explain how nRF51/nRF52 sleeps and wakes up with sd_app_evt_wait(). The sd_app_evt_wait() function actually just disables the CPU of nRF51/nRF52.

The current consumption to expect when softdevice is enabled and when in sleep mode is the sum of the following factors:

• System On base current -> 1.2 uA
• RAM retention when sleeping - configurable but by default 0.3 uA with all RAM is retained
• Consumption of RC low frequency clock source (LFCLK)+ RTC -> ~0.7 uA
• Consumption of external crystal low frequency clock source (LFCLK)+ RTC -> ~0.35 uA

So the expected current consumption should be: System ON, full RAM retention, Wake on RTC (with external crystal) -> 1.2+0.3+0.35=1.85uA

The nRF51-DK has 32kHz external crystal as source for the low frequency clock so 1.85uA is the expected current consumption value when using nRF52-DK

[annapalu]

I disable the initialization of uart and i2c, and i see a consumption of 300uA when advertising stop. With advertising starts current increase to 520uA: I have a timer that wakeup the device after 20 seconds from the end of advertising and RTC, but i think that the consumption is still high.

Thanks, Anna