UART break

[Sascha]

Hello together, i have a question to the uart hardware communication. I try to send 6 bytes from the nRF51 DK, S130, SDK12 (p0.09 tx) pin to another hardware rx pin.

My Init: uart_init() in main. Baudrate 115200, Flow Control Disabled.

UART: for each byte app_uart_put() to send bytes over uart.

When i take a logic analyzer, i see there are little breaks between the bytes i send.

When i take e.g. HTerm with an usb TTL-232R 3V3 cable there are no breaks between the bytes.

My problem is, if i send this 6 bytes to my external hardware, i should get an response message from hardware to the nRF51 DK. Test with cable i will receive it. But not with the nRF51 DK. Potential is the same! i think this breaks make some trouble. how can i fix it?

Thanks!!

[Sascha]

Thanks for your answer. Ok, i thought so. So, there is no way to shorten this 21 microseconds? Think its much time, if i will send a couple of data, compared to the cable variant.