Error while setting BLE OFF

[cedric]

Hello,

sd_ble_gap_adv_stop()

returns NRF_ERROR_INVALID_STATE

sd_ble_gap_disconnect(m_connx_handle,  BLE_HCI_REMOTE_USER_TERMINATED_CONNECTION);

Disconnects the device, but it reconnects in the following seconds.

Any idea?

[RK]

If sd_ble_gap_adv_stop() returns NRF_ERROR_INVALID_STATE then you are not advertising when you call it.

and if the device reconnects after disconnecting it it's because the device is set to reconnect after it's been disconnected, what's the device?

[cedric]

ok the hard fault was due to an other statement. So, finally, the main question that remains is how to to turn off the radio, using nrf 52 and S132. since radio registers are unavailable due to the use of softdevice.