Impossible to load .bin into PCA10040

[Javier]

Hi!

Friday I can load the binary into PCA10040 (blinky example) ands works well. But today I load de binary but not works, nothing happen.

I'm used this example /Nordic/nRF52/examples/peripheral/blinky/pca10040/blank/armgcc

and other this (softDevice s132) /Nordic/nRF52/examples/peripheral/blinky/pca10040/s132/armgcc

Which maybe the mistake?

Regards

[Jørgen Holmefjord]

I tried replicating your problem on a fresh Ubuntu (16.04) install, but I'm able to connect to the board just fine using JLinkExe. Is your board mounting the JLINK drag-and-drop station (/media/ubuntu/JLINK/) when you connect it to your computer? If so, can you put the board into bootloader mode (hold reset while powering the board), and try to copy the J-Link Interface MCU Firmware to the device, now mounted as BOOTLOADER?

[Javier]

Thanks very much Jørgen, works fine. Best regards