Any suggestions for handling a bricked custom board?
I'm pretty sure I know where the problem is in my code, but now I can't reprogram the board. I did have this happen once quite a while ago & the nRFgo Studio Recover feature worked fine. Unfortunately, not this time.
Using the command line options gives the same basic errors as the Studio:
nrfjprog --recover:
Applying pin reset if debugger is not active. System off disabled until pin reset or power on reset is done. Halting device. ERROR: Cannot connect to the nRF51 device.
nrfjprog -p
Applying pin reset. ERROR: Cannot connect to the nRF51 device.
I'm using nRFgo Studio version 1.15.1.2691.
Help?
