nrfL01P+ ACK on some pipe

[enzo]

My net is a star type with many nrfL01P+ units. Now i simply use only pipe 0 with no acknowledge (and same frequency for all units). My question is if can I use pipe 1 (for example) to privately comunicate, from one unit, with the centre of the network (main unit), using in this case Acknowledge, leaving others chips in no ACK state on pipe 0.

[ovrebekk]

Hi

If you enable dynamic payload length and dynamic ACK you can broadcast on one pipe, and send ACK'ed data on another, for sure.

Just make sure that only the two devices that are supposed to communicate with each other uses that pipe 1 address.

Best regards, Torbjørn

[enzo]

Thanks Torbjorn, i tried in the past in this way with no success; i'll test more carefully. Enzo

[ovrebekk]

Hi Enzo. Did you figure this out in the end?
I think I handled a similar case from you recently.