Hi, I have tested a sample code which sends some data through BLE in nRF52 development kit(PCA10400). The code is attached below.
nRF5_SDK_11.0.0_MPU6050_Acc_X_Output.7z
I was able to connect the nRF UART app with the nRF DK and could send data to the app. The app could also send data and was displayed in terminal.
Later I tried to program a BMD-300 module which is attached on an external board.I followed some steps to program the external module but couldn't succeed. I tried to do the same commands in the onboard nRF52 module and everything executed successfully. But from then the sample program which I atttached is not executing at all. Neither the iPhone's Bluetooth nor nRF UART app no longer detecting the device for this particular code. But the basic ble_app_uart code which comes along with the SDK is working. I haven't done any changes to the code. Does the nRFjprog commands changed anything in the chip? or Is there any settings I need to check in Keil?
There is one more code which is showing the same problem. nRF52-ADC-examples-master.zip This was also working previously, but not working now. Any help would be appreciated.
Thanks, Vishnu
