How to Reset nRf 8001

[Saurabh Gulia]

I have a custom PCB and i have connected the MISO,MOSI,SCK,REQN and RDYN line from the nRF 8001 to Arduino. And uploaded your code of ble_uart_project.ino but nRF 8001 does not started advertising. When i debugged closely i came to know that nRF 8001 does not get reset as i am not getting any event from lib_aci_event_get() function. Sometimes i got error printed on Serial Monitor and i.e "Error in Setup" . I even tried Projects given by Red Bear Labs with their libraries, but still not able to get any event from nRF 8001 and it clearly means that nRF 8001 is not getting Reset.Because as soon as it get Reset i will get an event ACI_EVT_DEVICE_STARTED, but i am not getting this evt.

The custom PCB and the connection are absolutely right and i am powering nRF 8001 from 3.3V supply only.In the above setup i have not connected Reset pin from nRF 8001 to anu pin on Arduino? Do i need to connect this? Can you provide the code snippet which actually Resets the nRF 8001. I had even tried resetting through soft reset with the help of this function lib_aci_radio_reset() but again the same issue?

Help me over this!!

[Saurabh Gulia]

Now i have connected the reset pin to Arduino pin 4 and also specified it like this aci_state.aci_pins.reset_pin = 4;

But still it is not advertising, actually i am not getting any evt from nrf 8001. I have read that if nrf 8001 will get reset then it gives ACI_EVT_DEVICE_STARTED but i am not getting this. How should i make this advertising? It has taken my so much tie but it is not advertising,help me in getting it start advertising.

[Nishant Sood]

I'm facing problem here>>

case ACI_DEVICE_SETUP: /* When the device is in the setup mode*/ Serial.println(F("Evt Device Started: Setup")); if (ACI_STATUS_TRANSACTION_COMPLETE != do_aci_setup(&aci_state)) { Serial.println(F("Error in ACI Setup")); }

I'm getting the Error in ACI setup. any reason why its so? and where this do_aci_setup() method is located?