This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

NRF52832 using tag connect

Looking for document or u tube to program nrf52832 using tag connect (6pin noleg) and nrf52 DK. Have the hex program and put it on the nrf582 dk. need to take to the next step

0 Jørgen Holmefjord over 8 years ago

Hi,

This should be quite straight forward. Connect your TagConnect cable to the debug output of the nRF52 DK, as described here, and program the external board as you would have programmed the DK. The DK will automatically detect the external board and flash this insted of the DK.

Best regards,

Jørgen
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel