Not able to perform DFU (FOTA) using nRF Connect Application or nRF ToolBox

[Monika Chaurasia]

Hi, I am trying to initiate Firmware Upgrade using the nRF Connect Mobile Application (also tried using nRF ToolBox).

As described in the below link - github.com/.../init packet handling

I created the ZIP File following the steps in the PDF file - How to create INIT File for nRF as mentioned in the link above. I have initiated upload using following steps -

1. ZIP File created using nRF UTILITY
2. .BIN and .DAT file

The error which I am getting is - After successfully starting Bootloader, the device is getting disconnected.

Please find the attached log of nRF LoggernRFLogger_Error.txt and .DAT Filefirmware.dat In the Log, you can see that after below byte is written to initiate DFU on characteristic, the connection is terminated. "D 14:38:28.776 [DFU] gatt.writeCharacteristic(00001531-1212-efde-1523-785feabcd123) A 14:38:32.142 [DFU] Jump to bootloader sent (Op Code = 1, Upload Mode = 4)"

Note: I am able to successfully perform DFU using Master Control Panel version 3.10 Device Information - Chip nRF52832, Softdevice support - S130 and S132. Mobile Used - Samsung A7 -2015, Android 6.0

[Monika Chaurasia]

Hi Hung, Thank You for your response.

Yes, I have generated the ZIP file from nrfutil.exe using below command - nrfutil dfu genpkg --application [application].hex --application-version [version] --softdevice [softdevice].hex --bootloader [bootloader].hex --dev-type [type] --dev-revision [revision] --sd-req [list of supported Soft Device ids] [name of the distribution packet].zip

SDK version which we are using is - SDK - 11

Connections fails as soon as it calls DFUTarg.

Let me know how can I resolve this issue at my end.