eclipse debug stuck in nrf52832

[sajin]

i am using nrf52832 and programmed it with eclipse by blinky example.. now i have to debug the project , but when i debug the project with the configuration given in tutorial it will stuck in "SEGGER J-Link GDB Server V6.12d - Terminal output channel" in the console ... cannt even run the program.. please help me

[Michael Lamming]

Not sure if this is relevant, but I have been struggling with a similar problem. In this document it says:

​Neon currently has several problems and is not-recommended: ​... on Windows, the OpenOCD debugging hangs while starting

on all platforms, the debugging consoles do not show.

[bjorn-spockeli]

Which version of Eclipse are you using? Neon or Mars?

[Stanislaw Maciag]

I had the same issue, as mikster suggested the problem was the Eclipse Neon IDE. The complete configuration was:

• Eclipse Neon.2 Release (4.6.2)
• GNU ARM Eclipse plugin 201606210758
• GNU Tools for ARM Embedded 4.9 2015q3
• Segger JLink Software V612d

It used to work for some time, then stopped running/debugging (hanging on "Launching: Configuring GDB", the console output the same like sajin's) for some reason that I was unable to find. Switching to Eclipse Mars solved the problem.

[Nguyen Hoan Hoang]

The recommended Eclipse version to use with the GNU ARM Plug-in is 4.5 Mars SR2, see this page.

However, Eclipse Neon.1 appears to works fine,but Neon.2 does not.

[sajin]

thank you @Nguyen Hoan Hoang you are right neon.1 works fine