JayT

[Jay Tyzzer]

Hello,

I in the nRF8002 data sheet it mentions a Programming tool for the nRF8002. Can you please send me the partnumber of this tool? Also, if a programming house wishes to do mass programming of the nRF8002, how would you suggest doing this activity?

"nRF8002 must be configured using the nRFgo Studio v1.12.3 or later. The configuration is downloaded through the UART, either directly from nRFgo Studio or by using the Production configuration tool available from Nordic Semiconductor. When downloading, you can choose to load the configuration into volatile memory (RAM) for development purposes or non-volatile memory (OTP) for production."

Thank you.

Jay

[Ole Morten]

This refers to the tool available on the programming tab in the nRF8002 part of nRFgo Studio, which can be run from the command line to program an nRF8002 over any serial port, for instance in a production setup.