nRF52832 cannot connect to J-Link

[Kewal Vora]

Hi, I followed the steps to setup my nRF52 DK with eclipse. I could also build the code without errors. However, when I try to debug it, it says cannot connect to J-Link.

The following is the output on my console

*SEGGER J-Link GDB Server V6.12a Command Line Version
JLinkARM.dll V6.12a (DLL compiled Dec  2 2016 16:44:26)
-----GDB Server start settings-----
GDBInit file:                  none
GDB Server Listening port:     2331
SWO raw output listening port: 2332
Terminal I/O port:             2333
Accept remote connection:      localhost only
Generate logfile:              off
Verify download:               on
Init regs on start:            on
Silent mode:                   off
Single run mode:               on
Target connection timeout:     0 ms
------J-Link related settings------
J-Link Host interface:         USB
J-Link script:                 none
J-Link settings file:          none
------Target related settings------
Target device:                 nRF52832_xxAA
Target interface:              SWD
Target interface speed:        1000kHz
Target endian:                 little*

***Connecting to J-Link...
Connecting to J-Link failed. Connected correctly?
GDBServer will be closed...
Shutting down...
Could not connect to J-Link.
Please check power, connection and settings.***

[Kewal Vora]

Yes, infact I copy pasted the "blinky" hex file in the JLink drive. It programs the board just fine. I can see the LEDs blinking one after the other. The problem comes when I have to do this from eclipse.