This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF52832 cannot connect to J-Link

Hi, I followed the steps to setup my nRF52 DK with eclipse. I could also build the code without errors. However, when I try to debug it, it says cannot connect to J-Link.

The following is the output on my console

*SEGGER J-Link GDB Server V6.12a Command Line Version
JLinkARM.dll V6.12a (DLL compiled Dec  2 2016 16:44:26)
-----GDB Server start settings-----
GDBInit file:                  none
GDB Server Listening port:     2331
SWO raw output listening port: 2332
Terminal I/O port:             2333
Accept remote connection:      localhost only
Generate logfile:              off
Verify download:               on
Init regs on start:            on
Silent mode:                   off
Single run mode:               on
Target connection timeout:     0 ms
------J-Link related settings------
J-Link Host interface:         USB
J-Link script:                 none
J-Link settings file:          none
------Target related settings------
Target device:                 nRF52832_xxAA
Target interface:              SWD
Target interface speed:        1000kHz
Target endian:                 little*

***Connecting to J-Link...
Connecting to J-Link failed. Connected correctly?
GDBServer will be closed...
Shutting down...
Could not connect to J-Link.
Please check power, connection and settings.***
Parents
  • So you Jlink is not working.

    If you are running Windows, look in the device manager and confirm that you can see the JLink in the "Universal Serial Bus controllers" section (its the section at the bottom)

    If you can't see the Jlink there, the chances are that its got a problem.

    If you bought your Jlink from eBay or AliExpress, I know that some of these have problems.

    I have my suspicions that the JLink software checks whether the Jlink has a blacklisted serial number and if so, it "bricks" it.

    There are however ways to unbrick Jlinks, which have been posted on various other forums.

  • Yeah, I couldn't find Jlink in the "Universal Serial Bus Controllers" section. I suppose I'd get a new one and try it again. Is there any other way to debug where I don't have to use the Jlink at all, only the DK? Thanks

Reply Children
No Data
Related