Can't write to Buttonless DFU service

[genis]

I am running the Buttonless DFU example in SDK 12.2.0 on a nRF52832. When I connect with NRF Connect, I can see the DFU control point but I can only enable notifications and read from it, not write to it.

Whenever I try to do a DFU with nRF Toolbox it fails, I guess because of that.

Is that normal? Shouldn't I see a writeable characteristic too?

[Vidar Berg]

The example didn't include the required write property for the control point, and would only work for peer devices that ignored it.

This is listed under known issues in the SDK release notes:

• Buttonless DFU Template Application (experimental):
  • The project setup of the example is wrong and does not fit into the available space below the DFU bootloader. To fix this problem, change the IROM1 size from 0x61000 to 0x59000. In addition, comment out the code section that reserves a codepage at 0x7E000 for MBR parameters. For details, see
    devzone.nordicsemi.com/.../
  • To switch to DFU mode, you must write to the DFU control point. However, this characteristic is set as read only. Add the following code line to enable the write property: char_md.char_props.write = 1; For details, see devzone.nordicsemi.com/.../

[genis]

Thank you, I hadn't seen those posts. That made it work.