Unable to run my program or examples

[Lezto22]

Hi Nordic developers.

I am developing a custom board using 2 Rigado BMD-300, but I am unable to run my 100% operative program or examples.

At first time I was able to see the rigado DFU service working on thoses chips (it was working) I used nrfjprog --family nrf52 --recover to remove the manufacter firmware then I programmed the Softdevice and the application, but the application does not start.

I was thinking the issue is hardware related, but how is it possible if the manufacter code was working from the first time I powered the devices?

I am able to debugging my code, read back my code from the rigado modules, but no able to start the program.

Info: SDK 12.2 nRF52 (rigado bmd-300), SD: s132, Interface programing: SWD (swdclk, swdio, GND)

Any suggestion?

See you

[Lezto22]

No, It does not. I noticed in debug mode it get stuck on ble_stack_init() also I noticed if I call uart_init() before the ble_stack_init() or any other clock related the debug mode get stuck there.

I moved my uart_init() after the ble_stack_init() and it get stuck on the next clock related function in this case I got stuck now on printf("Start Program\r\n"); -- It happens only on the affected module the others works with no issue.