Pullup/pulldown GPIOTE

[bitFrost]

Hi!

I'm reading the PS for nRF52832 and I can't find a clear answer on the following question.

If I set up a GPIO channel with pull-up/pull-down in the PIN_CNF[n] register and then want to use that channel as a GPIO task/event (GPIOTE). Does the GPIOTE logic some how remove my pull-up/pull-down setting or is it still active?

The reason I ask is that I understand that GPIOTE logic changes for example the GPIO configured DIR..

Best regards

[Jørn]

Hello bitFrost

The nrf_drv_gpiote_in_init will overwrite the pull config of your gpio pin. The function takes in three attributes, pin number, configuration of the pin and event handler. It is in the configuration struct the pull must be defined. If you look at line 495 in nrf_drv_gpiote.c you can see the function configures the pin with the pull specified in the config struct.

So to keep your pin configuration, make sure the config struct you forward to it has the right settings.

Best regards

Jørn Frøysa

[bitFrost]

Hi Jørn! My question was not about the SDK but the hardware. Will enabling the GPIOTE on one pin disable (or in any other way change) the configured pull-up/pull-down configuration on that pin? But I think I got the answer from the code you pointed me to. Thank you