nrf52 PPI+EasyDMA using timer and SPI

[Vishnu Pradeep]

Hi,

I am using nrf52832 for my application. The application share same SPI module for two sensors(with sensors are selected using two chip select pins). Is it possible to implement PPI channel between a timer and this SPI module so that I can collect data from both the sensors every 1ms? I would like to collect the SPI data using EasyDMA and send these data through BLE every 50ms. how can it be achieved with the help of PPI and EasyDMA?

[Wojtek]

Yes, it is possible. may be something like:

1. Setup spi, transmission buffers, timers etc
2. Start 1st SPI transmission (either by timer PPI or manually by software - every 1ms)
3. When transmission end, toggle CS pins by gpiote (triggered by spi end ppi), start timer
4. when timer end, start second spi transmission (buffer pointer automatically incremented by array list).
5. Data may be moved somewhere else, or just long arraylist may be used.
6. goto 2?

I may have skipped something, but in general, that should be doable. It also can be achieved quite easily completely without using ppi, timers etc - just by software app_timer, as 1ms is not that high freq.

About sending it by BLE every 50ms... I would just use app_timer too for that.

[Vishnu Pradeep]

Hi,

There is a small change in my application. I have an AFE and an accelerometer, both SPI, connected to same SPI channel. My goal is to read SPI data every 100ms from both the sensors. One of the sensor reads 75 bytes of data and the other reads 5 bytes at this instant. Will it be possible by the above method as @Wojtek suggested? The data has to be read with EasyDMA and stores in an array. Then the collected data has to send every 'x' seconds(This amounts 800+ bytes).