This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

On-Board programmer erased, How to reflash it? What to reflash?

On a NRF52DK Board, There is an on-board programmer done with ATSAM3U2C seen as a Segger programmer or a Jlink Progammer.

By mistake, I erased the entire flash of this programmer. I know it's possible to change its firmware with the IF BOOT/RESEST Boutton. But i think I erased the bootloader that allow that.

I'm trying to reflash it through Sam-ba bootloader of Atmel but I can't find a firmware that boot correctly. I tried this firmware and this one

But It doesn't seem to boot.

Parents
  • Hi Rishi,

    When I plug the board on a windows, it's seen as a Bossa Com Port. On a linux, it's shown as a AT91_Sam-BA_Bootloader (the Lowlevel bootloader from Atmel for their chip). I don't have the directory opening and the blinking led when I plugg the board with "IF BOOT/RESET" pushed unlike Gaute Gamnes's procedure.

    I think I erased the code responsible of that... and i can't find it.

Reply
  • Hi Rishi,

    When I plug the board on a windows, it's seen as a Bossa Com Port. On a linux, it's shown as a AT91_Sam-BA_Bootloader (the Lowlevel bootloader from Atmel for their chip). I don't have the directory opening and the blinking led when I plugg the board with "IF BOOT/RESET" pushed unlike Gaute Gamnes's procedure.

    I think I erased the code responsible of that... and i can't find it.

Children
Related