This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Chip Antenna Pi Network Circuit Layout

Hi there!

I'm looking to layout a chip antenna using the nRF52832 WLCSP chip and am confused about the layout of the antenna matching circuit. The reference design (CIAA) provided by Nordic has a layout with one cap, one inductor and a PCB antenna. I have read that this design should be copied exactly, however, the chip antenna spec shows a different layout for the matching circuit. I am not sure which layout to follow.

I understand that since I am using a chip antenna, I am better off with a 3-component pi matching network. Should I simply add another capacitor to the CIAA reference design from Nordic? Ideally I would place my network close to the ANT pin of the nRF but not in the exact layout to save space, since it is a board limited design.

The antenna I am using is: AF 216M245001

Any help is appreciated, Parth

Parents
  • All antennae have different matching requirements. A Pi network is sort of the RF equivalent of everything but the kitchen sink. The Pi network gives you 2 shunts and one series component which can normally solve the worst of matching disasters.

    On the reference designs, the PCB antennae generally have simple matching needs that Nordic has painstakingly reduced to the fewest components.

    However, your chip antenna even if you do a really good job of following the manafacturers layout guidelines may not have a simple match. Therefore it is better to put spots for 3 components (ie, Pi) vs just a single shunt or something else.

    You will have to determine which components and values are required by actually matching your antenna after you spin your board. Generally, if some of the Pi is unused it is better to leave well enough alone and do not change the layout. You would likely change the match by changing the layout.

    1. So do the layout per the antennae manufacturers spec.
    2. Place a Pi network in the 50ohm feed to the antenna where there is a stable ground plane. Normally this is close to the nRF.
    3. Spin the board
    4. Figure out the match for the antenna.
  • Okay understood. I was confused that the Pi network and the nRF matching network were one in the same. So in total my matching for both the nRF and antenna would be 5 components to be as safe as possible. A 2-component matching for the nRF and a 3-component Pi network following it to match the antenna.

Reply Children
No Data
Related