ADC Sampling with Softdevice

[dev_000]

Hi Everyone,

I am working on a hobby project with nRF51822 which needs me sample upto 4 signals reliably at 500Hz each at 10bit resolution. I have read through few posts in the forum([1],[2],[3]) and found that with softdevice installed ADC sampling rate drops to 1KHz(Or Is it 2KHz? As one forum post was suggesting so)

So for my requirement, I am assuming nRF51822 might not be good enough as sampling rate would drop to 1KHz/4 = 250Hz as I have four channels? I would like to know what my options are to implement this spec at 500Hz/channel?

1. Is there way to do 500Hz/channel for 4 inputs with latest softdevice installed? (Connection Interval: 7.5ms, Slave latency: 0ms, 1 packet(<20bytes of data) of data transfer per connection interval)
2. If I compromise on the sampling rate to 250Hz/channel(or dropping it to 8bit resolution), would I be able to reliably sample all channels with SD installed?
3. If its No to the Question 1, is my only option to go for an external ADC with higher sampling rate and transferring data to nRF51822 via SPI?
4. Is it better for me switch to nrf52840(Preference is still towards nRF51822)? I have PDK which I can work with for this project. I haven't searched around in the forum for ADC performance of nRF52840 with s140 SD.

Thanks in advance.

[Jørgen Holmefjord]

Hi,

Have you tested this with your own application? As Stefan mentioned in the 3rd post you linked:

If you use softdevice and have 3rd revision nRF51, you can obtain sampling frequency approximately 2-8 kHz, depending on how much data you send over the air.

Your data requirements does not look that high, that you should not be able to maintain the sample rate you desire. Here is an example that you can try if you want a ready-made example.

The nRF52840 PDK (or nRF52 DK) would be a better choice, as it has a faster SAADC peripheral and support for EasyDMA, allowing you to continue sampling directly to RAM, while BLE activity is going on.

Best regards,

Jørgen

[dev_000]

@Jorgen Thanks. I haven't tested it out yet. Still in design phase. Hence wanted to know which platform to use before jumping in.

1. Can I know how 2-8KHz is calculated? I saw this link and Pg 41 of S110 SD Specification V2.0 but I still unclear how those actual numbers came about.

2. I am assuming the above sampling limitation wont there for nRF52480 because of Easy DMA transfer?

3. Is there a better product datasheet for nRF51822 than this? I am not seeing enough details on it as compared to lets say, objective product specification sheet v0.5 of nRF52480, which explains the subystems in great detail. Am I looking at the wrong files of NRF51822?