This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SDK V13 ble_app_att_mtu_throughput not working

I followed the link: infocenter.nordicsemi.com/index.jsp to build and load the app into two boards.

Step 1 ~ 8 are working as expected. But

Step 9 "Observe that LED 2 turns on on both boards and that the tester prints "Test is ready. Press any key to run." on UART." never happened, ie. the two boards are not ready to run further test.

Please help. Thanks.

Parents

0 Rbai over 8 years ago

I reinstalled the sdk v13 and compile the app fresh, and it worked. So it must be something in the lower level that I had modified broke something. Thanks.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Rbai over 8 years ago

I reinstalled the sdk v13 and compile the app fresh, and it worked. So it must be something in the lower level that I had modified broke something. Thanks.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data