nRF51 doesn't show up anymore aftering bootloader mode

[hasanble]

Hello,

After (accidentally) entering bootloader mode on my nRF51 DK (PCA10028), the device doesnt show up either in the device manager or using nRFgo Studio (both not normally, as being in the bootloader mode where LD5 is blinking.)

In case I turn the DK on and off normally (without pressing the reset button), the LD5 doesnt blink or turn on otherwise. If I turn the DK on while holding reset, BOOTLOADER shows up as a USB device, and the LD5 blinks.

Can anyone help me out, thanks in advance.

[Simen August Tinderholt]

Have you tried reprogramming your debugger?

Enter bootloader mode and drag and drop a debugger firmware image onto the drive. The image can be found at nRF5x-OB-JLink-IF. After programming is done, the green debug led should start flashing rapidly. After power cycling your board it should be back to normal.

[Nesara.S.R]

I am currently facing the same problem with nrf52832 dongle. Its DAPLINK based. Do you know where i can find the debugger firmware image for the same?

[bjorn-spockeli]

Nesara.S.R:

Do you mean the nRF52840 Dongle? If so then the Open Bootloader is available here: https://github.com/NordicSemiconductor/nrf-device-setup-js/tree/master/bootloader