ble_uart example

[Poonam]

i am using customized board for nRF52832. i am using ble_uart example code. in that example LED1 on nRF52_DK board is used for indication for ble connectivity.

in my customized board i am using only LED which is connected to P000 . i am not using any button . how to configure new port pin for ble indication LED.

[FormerMember]

The easiest way to control the LED is to use the nrf_gpio interface directly:

1) Configure pin as output: nrf_gpio_cfg_output(pin_number)

2) Turn on/off the LED:

• nrf_gpio_pin_set(pin_number)
• nrf_gpio_pin_clear(pin_number)

[FormerMember]

The LEDs and buttons used in the example are defined in pca10040.h

To define your own board, and use those defines instead, you should do the following:

1) Create your own .h file for the board specific defines: custom_board.h

2) in Project --> options for target --> C/C++ define: Replace BOARD_PCA10040 by BOARD_CUSTOM