I use nRFgo Studio 1.21.2.10 and J-Link V5.12f.
In nRFgo Studio I can erase my nrf52. However, programming with softdevice or application ends with error Unable to find or open the JLinkArm dll.
Note: I use some IDE and they are able to program my nrf52 using J-Link V5.12f.
I tried: Complete uninstall of nrfgo studio, tools and jlink driver, then reinstall. Nothing changed.
Hello MartinD,
I am also getting same error. However I am able to program the controller which is present on PCA10040 board. I am getting below error. I had removed nrf command line, nrfgo studio, segger embedded studio, updated jlink and reinstalled all but I am getting same error.
Some time I get the below error.
did you resolve this issue? if yes how?
Hello MartinD,
I am also getting same error. However I am able to program the controller which is present on PCA10040 board. I am getting below error. I had removed nrf command line, nrfgo studio, segger embedded studio, updated jlink and reinstalled all but I am getting same error.
Some time I get the below error.
did you resolve this issue? if yes how?
