Hi,
I change the example ant_broadcast to acknowledge mode, but it seems that without a peripheral side,the LED0 will still twinkle.I don't know how to change the project so that only with a receiver will the sender send a successful date.
Hi,
I change the example ant_broadcast to acknowledge mode, but it seems that without a peripheral side,the LED0 will still twinkle.I don't know how to change the project so that only with a receiver will the sender send a successful date.
I add one more situation under the event,that is EVENT_TRANSFER_TX_COMPLETED.And it seems to fit me request,is is right?
With the EVENT_TRANSFER_TX_COMPLETED included the board is behaving as expected or do you still see LED blinking without getting the ACK?
Thank you for your reply,I think that is the answer.But still,I have some doubt,when the chip send the message "time out",how to reconfigure the channel parameters to set up a new channel?or must it be reset?