This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

open mesh dfu update new app breakdown.it seems a bug ?

hi： i flashed bootloader_serial_xxAC.hex and s110_nrf51_8.0.0_softdevice.hex with nrfjprog. and flashed flash_page.hex, then update app using mesh serial, the app run well when reset. but i modified app version ,Packaged into a new upgrade pack， update app using mesh serial， It's stuck！ thanks for any help！

image description (/attachment/c8d4b5d01f01e559a374aa791e3c97cc)

0 Hung Bui over 7 years ago

Hi Mr_sev,

Please attach your bootloader, flash_page, flash_page.hex, your application .hex (you can use the gateway example ), and the 2 .zip files you generated so I can test here.
Cancel
Vote Up 0 Vote Down

Cancel
0 mr_sev over 7 years ago

Thank you very much for your help！
Cancel
Vote Up 0 Vote Down

Cancel
0 mr_sev over 7 years ago

hi Hung Bui. How about the test result? update file
Cancel
Vote Up 0 Vote Down

Cancel
0 Hung Bui over 7 years ago

@mr_sev: sorry I was busy and it was Norwegian holiday yesterday, I will try to do some test by the end of the week.
Cancel
Vote Up 0 Vote Down

Cancel
0 Hung Bui over 7 years ago

Hi Mr_sev,

I assume you are using the master branch from github . We are suspecting DFU is broken on this version.

Please try using the release version 0.8.7 here.

I just tested with your application and it worked fine for me. I managed to do DFU update the application.

Please use the pre-compiled bootloader.hex to test first. Here is application version 4, and 5 that I used and the bootloader and it worked.

app4.zip

app5.zip

bootloader_serial_xxAC.hex
Cancel
Vote Up 0 Vote Down

Cancel