This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Flashing Interface MCU for nRF52PDK

Hi,

May I know, How to flash the firmware for ATSAM4 which is used for flashing and debugging nRF52840. And also how to get the firmware?

Parents
  • Hi,

    The procedure to flash the interface MCU of the nrF52840 PDK is described on this infocenter page.

    The J-Link OB IF firmware can be found here.

    Best regards,

    Jørgen

  • Thanks a lot Jorgen,

    In infocenter page it is mentioned that "The on-board interface MCU is factory programmed with an mbed compliant bootloader". Actually I am planning to make a small board with just nordic radio and the firmware interface controller by referring through PDK schematic. So, I have to purchase ATSAM4 and nRF52840 and integrate them. In this context, what would be the procedure to flash?

Reply
  • Thanks a lot Jorgen,

    In infocenter page it is mentioned that "The on-board interface MCU is factory programmed with an mbed compliant bootloader". Actually I am planning to make a small board with just nordic radio and the firmware interface controller by referring through PDK schematic. So, I have to purchase ATSAM4 and nRF52840 and integrate them. In this context, what would be the procedure to flash?

Children
No Data