Use signal Active on nRF8001

[PatDes]

Hello, What is command to set signal ACTIVE on nRF8001? I want use this signal to drive SKY66112. Best regards

[Jørn]

Hello PatDes

The Active signal of the nRF8001, and its polarity, is set in the hardware configuration of the Setup commands. When using nRFgo Studio you find it under the tab "Hardware Settings".

Also, do note that the maximum output current from the pins of the nRF8001 should not exceed 0.5 mA, see page 34 of the product specification.

Best regards

Jørn Frøysa