nrf52840 Power Consumption

[HardwareGuy]

Hi There,

I am doing current measurements on the nrf52840 in sleep mode with no RAM retention and I am getting different values based on how I take the measurements. Please see the various methods and resulted below.

1. Using an amp meter in series with P22 - SW10 = On | SW6 = nRF Only | VP21 = 3.3V
   13.2 micro amp

2. Using and amp meter in series with P22 and power from USB header J2 - SW10 = off | SW6 = nrf ONly 1.3 micro amp

3. Using and amp meter in series with P21 - SW10 = On | SW6 = nRF Only | VP21 = 3.3V 1.46 micro amp

4. Using and amp meter in series with P21 - SW10 = On | SW6 = default | VP21 = 3.3V 0.1 micro amp

5. Using the PPK with jumper SB40 open 33 micro amp

Can you please help me to understand why these numbers are so different. I believe that method 2 above is probably the correct value, even though it does seem a bit high. Isn't the nRF52840 supposed to draw around 500 nA in sleep mode? Your help would be much appreciated.

[Stian Røed Hafskjold]

Hi,

Sorry, but it is not easy to measure current on the nrf52840 preview DK (pca10056 0.9.0). I tried different setups here too, but I was not able to get the lowest currents accurate enough. USB will cause a lot of noise, so usually the measurements become more inaccurate with USB. I get the best results if I power the DK from a stable voltage source on P21, and measure current through P22. SW10 Off, SW6 nrf only.

EDIT

Please disregard the above. What I did wrong was not to power the DK through USB. Even though you power the nRF chip from P21 you still have to power the DK through USB in order for everything else on the DK to work properly. The following should give good results:

• main USB connected
• stable voltage supply on P21
• SW10 -> ON
• SW6 -> nRF ONLY
• SW9 -> VDD
• Cut SB40 and measure current through P22