Help for Beginners

[abuzar12]

I am new to nRF 52. Previously i have worked on arduino IDE for programming arduino uno,mega. I have also used MPlabX for programming PIC(MircoChip) series micro-controllers. I dont know where to start programming nRF 52 development board! What are the register,timers,interrupts etc in nRF 52832? What language to use. I want to start form basics. I have installed keil, saw some examples but found them difficult to understand as i dont know the basics. What to do now, any help would be appreciated!

[endnode]

Hi, if you want to start from the beginning then you can go with great list of Nordic tutorials here and Getting Started entry point here. When you will brows Nordic Infocenter you can see that basically all the documentation is available on-line so you usually find answers to 99% of questions there. However if you encounter any specific issue when following the examples/tutorials or when working with HW/SDK don't hesitate to describe it in detail and post as question here, Nordic team is very reactive!

[abuzar12]

Thanks for the advice. Can you plz tell me some basics.

1. how to make any pin input/output? 2)how to name any pin? 3)how to read from a pin? 4)how to write to a pin?

both in the case of digital and analog

[endnode]

Hi, I'm afraid that's all in numerous Nordic SDK examples and blog posts, I cannot help you further...

[Jørgen Holmefjord]

Check out this thread about GPIO usage.