Looking at the nRF8001 DK User Manual: http://imgur.com/a/NyY0L
It is unclear how pins 2-10 are organized.
Looking at the nRF8001 DK User Manual: http://imgur.com/a/NyY0L
It is unclear how pins 2-10 are organized.
Hi,
The pins are organized as shown in the nRF8001-DK HW files (pin 1 is marked on the board):
Best regards,
Jørgen
Ok, if there are no objections, I will get a TXB0108 then. Thanks. Edit: This is for ACI, so I need 3 high-to-low conversions and 2 2 low-to-high. Someone said that although TXB0108 is bidirectional, all channels have same direction at a time. But low-to-high should not need any translation (right?). Hence I could use that board for the high-to-low conversions, and have no low-to-high conversion. Sounds okay?
Ok, if there are no objections, I will get a TXB0108 then. Thanks. Edit: This is for ACI, so I need 3 high-to-low conversions and 2 2 low-to-high. Someone said that although TXB0108 is bidirectional, all channels have same direction at a time. But low-to-high should not need any translation (right?). Hence I could use that board for the high-to-low conversions, and have no low-to-high conversion. Sounds okay?