PPK nRF6707 v1.1.0 problems

[rastik]

Hello, has anyone tried new v1.1.0 for nRF6707? If I change the window size to more than original 2.0s, GUI becomes very laggy and it is very hard to stop the recording - e.g. with window size 7s it takes more than 10 seconds to stop. By that time all the measurements I need are long gone.

[Sigurd]

Hi,

Please try this method described in Chapter 10 Troubleshooting in the PPK User Guide v1.1:

The graph response is very slow:

Avoid using USB hubs and docking stations. Also, if the trigger window is receiving a lot of updates, consider stopping this plot to have better throughput for the Average plot.

[rastik]

Thank you for pointing that part of documentation. But none of that helps. I'm using v1.0.0 again and it works fine for me.

[wlgrd]

We haven't had any reports that there is a difference between the two versions. Sure you have flashed the latest firmware when running 1.1.0?

[ThierryC]

I have the same issue of lagging UI (sometimes it takes more than 10 seconds to display 0 mA cunsumption when I disconnect my device) since I updated the PPK to v1.1. And this regardless if USB is connected through a hub or directly. Reproducible also on another PC. Was working fine with v1.0.