I'm trying to program an external NRF52832 board with the NRF52-DK, per the instructions in this post.
Programming works fine, but the code doesn't execute after reset. I'm using nrfjprog (on OSX) with --chiperase --program and --reset. The code doesn't run until I manually power-cycle the external board. Then, interestingly, if I issue another command with only --reset, the code stops until I power-cycle again.
Any thoughts on what might be causing this?
Using nrfjprog version: 9.4.0, JLinkARM.dll version: 5.10d
--log log.log file
Which version of nrfjprog are you using? Could you also run the command with the --log option and post the log here?
Thanks for the reply. Added the requested info to the initial post above.
There should be a log.log file in the folder where you called nrfjprog from.
Thanks! Updated again.
The logs look fine, but could you try to update your nrfjprog to v9.6.0(link ) and JLink to v6.16 (link) and see if that solves the issue. Is the external nRF52832 board a custom board?