NRF52832 - Monopole Antenna on 24mm Dia PCB

[Bhaskar]

Hi,

I need to design a small nRF52 board On 24mm Dia 2-layer PCB, same like nRF51822 Bluetooth Smart Beacon Kit (nRF51822 Coin-Cell design). Please find the attached Schematics and layout files for your reference.

For mono-pole antenna,Layout Reference taken from nRF51822 Coin-Cell design, and rest from the nRf52 DK ref design especially in the case of the antenna matching circuitry (components between device pin ANT and the antenna).

I am looking for a range of around 40-50 meters. Please review and let me know any suggestions to achieve best performance of the antenna. Thank you very much for your time and if you need any more information, I will gladly supply it..

NRF52832 Schematics.pdf

Gerber.zip

NRF52832-ERAATA-138.png

[bjorn-spockeli]

Hi Bhaskar, you are completely correct, 100nF == 0.1uF, . Again, you are correct, those pins should be grounded according to erata 138. I stated pin 44, but meant pin 45, which should be connected to the same ground plane as the ground pad of C2. However, it might not be strictly necessary. After discussing your layout with a colleague I would recommend extending the ground plane past D1 by moving the power line a bit in and then adding more vias at the red dots, see the attached screenshot. Furthermore I would also extend the antenna by 2-3mm as this is going to be handy when you're tuning the antenna by cutting in order to adjust the length