Hi there, I have four nRF52 DKs, 52832 board. I make one board as client and three boards as server. After flashing corresponding softdevice and application firmware, they can start to run. But after provisioning, I tried to press button to control the light on or off, I found that:
0> <t: 186081>, main.c, 221, Button 1 pressed
0> <t: 186084>, main.c, 224, Not in RUNNING state
I don't know why the state is not in running state, how can I fix it? The log after client reset is below:
0> <t: 0>, main.c, 318, ----- BLE Mesh Light Control Client Demo -----
0> <t: 0>, main.c, 108, Initializing softdevice
0> <t: 0>, nrf_mesh_sdk.c, 109, Initializing SoftDevice...
0> <t: 2>, nrf_mesh_sdk.c, 118, Ram base: 0x200022D8
0> <t: 15>, nrf_mesh_sdk.c, 123, sd_ble_enable: app_ram_base should be adjusted to 0x200019C0
0> <t: 20>, main.c, 116, Initializing mesh stack
0> <t: 313>, main.c, 123, Enabling mesh stack
0> <t: 325>, main.c, 141, Setting up access layer and models
0> <t: 365>, main.c, 265, Configuration of device 0 successful
0> <t: 368>, main.c, 265, Configuration of device 1 successful
0> <t: 164214>, main.c, 221, Button 0 pressed
0> <t: 164217>, main.c, 224, Not in RUNNING state
0> <t: 186081>, main.c, 221, Button 1 pressed
0> <t: 186084>, main.c, 224, Not in RUNNING state