This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Sleep Immediately after Beacon Advertisement

I'm using the following code to make the beacon sleep:

static void on_ble_evt(ble_evt_t * p_ble_evt)
{
    uint32_t        err_code;
    switch (p_ble_evt->header.evt_id)
    {
        case BLE_GAP_EVT_CONNECTED:
        {
            break;
        }
        case BLE_GAP_EVT_TIMEOUT:
        {
            if (p_ble_evt->evt.gap_evt.params.timeout.src == BLE_GAP_TIMEOUT_SRC_ADVERTISING)
            {
                sd_ble_gap_adv_stop();
                ble_fsm_set_state(Ble_Fsm_State_Idle);
            }
            break;
        }
        default:
        {
            break;
        }
    }
}

Once the state is set to idle, the nrf51 chip goes to sleep and the current draw drops to the order of uA. My only problem here is that the minimum timeout value is 1s and this means that the chip is burning power for 1s. Ideally, I would like the beacon to just advertise once and then go to sleep immediately. What is the best way to do this? Adding a synchronous delay of 5 ms? Any callback that I can use instead?

Parents Reply Children
No Data
Related