This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Communication with MT8852B

Hi I am sending my BT module with nRF51822 for some regulation test and the Test Lab is using Anritsu MT8852B to communicate with my module through USB-to-UART adaptor and they found the equipment cannot find the address of the module. What is the suggestion to do? In fact, this module is tested and passed with another BT test Lab for another testing under 7-layer equipment so I believe there is some setting problem on it and please give me some recommendation on it.

Parents
  • Thanks RK and endnode to answer my question. Firstly, "cannot find the address of the module" is feedback from test Lab and I will check with them to clarify their problem. For the software inside, we are using the code to match DTM test inside nRFgo Studio so I cannot 100% sure this firmware can connect to BT tester with standard BT DTM (test) and HCI command or not. What is your recommendation to make the firmware to well communicate with standard DTM(TEST and HCI command?

Reply
  • Thanks RK and endnode to answer my question. Firstly, "cannot find the address of the module" is feedback from test Lab and I will check with them to clarify their problem. For the software inside, we are using the code to match DTM test inside nRFgo Studio so I cannot 100% sure this firmware can connect to BT tester with standard BT DTM (test) and HCI command or not. What is your recommendation to make the firmware to well communicate with standard DTM(TEST and HCI command?

Children
No Data
Related