This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Maximum allowed output power ESB

Hi Nordic folks,

We are developing a product using nRF52832 with a Power Amplifier (RFX2401C) for extended range. For communication we are using ESB with some modifications to allow the use of a PA. The PA will add +22dBm to the output power.

We plan to release the product in Europe and USA.

Do anyone have a summary of what we will have to do to comply with the regulations in these countries? I am sure that someone has had the same kind of problem before here.

I have read a bit of the regulations for devices operating in the 2.4GHz band in Europe (EN 300 328), but as most of these documents this can be hard to read sometimes. Therefore we would like to know if someone on this forum has some tips.

Parents
  • Hi Rick,

    As far as I know, you're allowed to transmit up-to +30dBm in the US as long as the bandwidth at 6dB is larger than 500kHz.

    In Europe there are several regulations when transmitting above 10dBm, described in ETSI EN 300 328 Chapter 4.3.2. The most "problematic" part is 4.3.2.3 Power Spectral Density, which is limited to to 10dBm per MHz. Thus, with a 2MHz bandwidth the maximum output power of 13dBm, transmitting above this limit will require you to hop between frequencies (minimum of 15 channels)

    In addition there is a requirement to "Listen Before Talk" (chapter 4.3.2.6.2.2), i.e. you need to check whether the channel is used or not before transmitting as well as requirements of the Medium Utilization, i.e. duty cycle.

    Best regards

    Bjørn

  • LBT refers to clear channel assessment and has nothing to do with protocol. The radio simply listens to see if there is RF energy on the channel before it tries to transmit. It has been part of 802.11 wifi since its beginning though not as common in other protocols. It works to mitigate lost packets from collisions (two devices transmitting at the same time). Likely etsi chose to write it in as a requirement because they are more of a standards oriented organization and write rules for the best possible user experience. They are very different from the fcc who really don't concern themselves with how a band is being utilized as long as you are not imparing licensed and government bands.

Reply
  • LBT refers to clear channel assessment and has nothing to do with protocol. The radio simply listens to see if there is RF energy on the channel before it tries to transmit. It has been part of 802.11 wifi since its beginning though not as common in other protocols. It works to mitigate lost packets from collisions (two devices transmitting at the same time). Likely etsi chose to write it in as a requirement because they are more of a standards oriented organization and write rules for the best possible user experience. They are very different from the fcc who really don't concern themselves with how a band is being utilized as long as you are not imparing licensed and government bands.

Children
No Data
Related