Flashing a 3rd party NFR52832 with ST link V2 on Eclise?

[MikeLemon]

Hello,

I am in a little bit of trouble here trying to flash a 3rd party module that is mounted on a custom PCB I made with the SWD pins exposed for programming.

I've been using it with the Arduino IDE and the st link V2 so far(Thus flashed softdevice S132 on it already) but I want to make the transacting from it sins it lacks capabilities. any way I know it works in term of hardware.

Now I'm not interested in wasting my money on buying the Segger J link so I want to use the ST link V2 so far I've followed this tutorial: devzone.nordicsemi.com/.../ up to the point of "Flash download" build the blinky code successful and waiting to see how you flash the chip with it.

Does anybody have any experience with it? thanks for your time.

[MikeLemon]

Yeah so this is still relevant.

[endnode]

(2/2)

• Now recompile the project again and it should pass (HEX binary should be produced).
• In the end if your STM32 dev kit really works as SEGGER J-Link it should be connectable to your machine and Keil exactly the same way as nRF52 DK so all what is explained in the Keil and BLE blinky tutorials by Nordic on this site should be applicable.

If you encounter any problem, please set new question where you exactly explain what HW and SW are you using, what steps you made, what you expect to see and what happened instead. I'm sure you will get further support...