Hi, Schematic and Code As shown above, VCC 3V (DEC2 and VCC open) current is only 3.8uA, but VCC 1.8V (DEC2 and VCC short circuit) current exceeds 1mA, what am I mistaken? Would like to hear any suggestions about Low voltage mode, thank you!
Hi, Schematic and Code As shown above, VCC 3V (DEC2 and VCC open) current is only 3.8uA, but VCC 1.8V (DEC2 and VCC short circuit) current exceeds 1mA, what am I mistaken? Would like to hear any suggestions about Low voltage mode, thank you!
No.
nRF5x hardware will operate at 1.8V, and the software is voltage independent.
See
www.nordicsemi.com/.../nRF52832
or
Hi,
Please make sure you do a power-reset before starting any measurement. After programming the chip the nRF51 will stay in debug mode which consumes ~1mA
Hi,
Please make sure you do a power-reset before starting any measurement. After programming the chip the nRF51 will stay in debug mode which consumes ~1mA