State Verified Answer
Locked Locked
Replies 4 replies
Subscribers 74 subscribers
Views 4607 views
Users 0 members are here

Attachments (0)

Nordic Case Info

Case ID: 124114

Options

This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IO pin signal during reset

roger.k over 7 years ago

Hi. I'm using nRF52832.

During reset(HW reset), IO pins are output? or input? If output, level high? or low?

I need your help.

Top Replies

Joakim Jakobsen over 7 years ago +1 verified

Hi roger.k! As we can see from the nRF52 product specification , the GPIO pins will be set as input after the reset. Best regards Joakim

Parents

0 Joakim Jakobsen over 7 years ago

Hi roger.k!

As we can see from the nRF52 product specification, the GPIO pins will be set as input after the reset.

Best regards
Joakim
Cancel
Vote Up +1 Vote Down

Cancel
0 roger.k over 7 years ago in reply to Joakim Jakobsen

Thank you very much for your help. What I really want to know is "During reset" not "after reset". During HW reset pin is LOW, IO pins are output? or input? If output, level high? or low? I need your help.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 roger.k over 7 years ago in reply to Joakim Jakobsen

Thank you very much for your help. What I really want to know is "During reset" not "after reset". During HW reset pin is LOW, IO pins are output? or input? If output, level high? or low? I need your help.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Related