Hi Nordic team,
I try to use SDK for Thread v0.10.0 cli example and run diag command, but it is disable as below
Could you tell me how to enable diagnostics module ? Thanks
Hi Nordic team,
I try to use SDK for Thread v0.10.0 cli example and run diag command, but it is disable as below
Could you tell me how to enable diagnostics module ? Thanks
you need to first enable the diag features by the command
> diag start
you need to first enable the diag features by the command
> diag start
Hi Aryan,
Thanks for your reply. I couldn't run any command after "diag start" command because of console hang up. From the github.com/.../diag, console should display "start diagnostics mode" message after "diag start" command, right ?
Hi Nordic team,
I couldn't enable diag feature by "diag start" command and my test firmware is nRF5_SDK_for_Thread_v0.10.0/examples/thread/experimental/cli/hexnrf52840_xxaa.hex. Symptom is nRF52840 DK console hang up after running "diag start" command
Could you provide some solution ? Thanks Thanks