nrf24l01 playload datarate

[pengyong]

When I have a test using nRF24l01+ with STM32, I can only get a playload datarate no more than 450kbps using nRF24l01+ 2M mode. How can increase the playload data rate and what is the maximum for the playload data rate? Thanks.

[pengyong]

Hi Torbjørn,

It is great. I will try the though put 1.5Mbps.It is very important for my application. Could u give me some advice for the configuration to enabled over multiple packets and to to upload the next packet to the FIFO? Looks there is no more detail specification on datasheet document.It will be very helpful to me if there is a demo for the configuration. Thanks.

Yong

[ovrebekk]

Hi

The procedure is quite straight forward:

1. Set CE high
2. Upload a packet to the TX FIFO as quickly as possible
3. If time passed is less than 4ms, repeat from 2)
4. Set CE low
5. Wait for the next TX interrupt to occur
6. Repeat from 1)

Best regards

[pengyong]

It is ok now. The through put is muck higher than before. Thanks a lot.

[ovrebekk]

That is good news :)
The best of luck with your project.